Replacing The Lamp - Zanussi ZZP37901XX User Manual

Close the oven door
3
halfway to the first
opening position.
Then pull forward and
remove the door from
its seat.
Release the locking
5
system to remove the
glass panels.
2
1
First lift carefully and
7
then remove the
glass panels one by
one. Start from the
top panel.
Clean the glass panels with water and soap.
Dry the glass panels carefully.
When the cleaning is completed, install the
glass panels and the oven door. Do the above
steps in the opposite sequence.
Make sure that you put the glass panels (A, B
and C) back in the correct sequence. The
middle panel (B) has a decorative frame. The
screen-printing zone must face the inner side of
the door. Make sure that after the installation
the surface of the glass panel frame (B) on the
www.zanussi.com
Put the door on a soft
4
cloth on a stable
surface.
90°
Turn the two
6
fasteners by 90° and
remove them from
their seats.
screen-printing zones is not rough when you
touch it.
A B C
Make sure that you install the middle panel of
glass in the seats correctly.

Replacing the lamp

Put a cloth on the bottom of the interior of the
appliance. It prevents damage to the lamp glass
cover and the cavity.
WARNING!
Danger of electrocution! Disconnect
the fuse before you replace the
lamp.
The lamp and the lamp glass cover
can be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or
deactivate the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise
to remove it.
19