Cisco ASR 900 Series Configuration Manual page 36

Configuring REP Configurable Timers
Command or Action
Step 7 rep lsl-retries number-of-tries
Example:
Router(config-if)# rep
lsl-retries 3
Step 8 rep lsl-age-timer timer-value
Example:
Router(config-if)# rep
lsl-age-timer 200
Step 9 rep preempt delay seconds
Example:
Router(config-if)# rep preempt
delay 60
Step 10 end
Example:
Router(config-if-srv)# end
Step 11 show interface type number rep
[detail]
Example:
Router# show interface
Gigabitethernet0/0/1 rep detail
Step 12 copy running-config startup-config
Example:
Router# copy running-config
startup-config
LAN Switching Configuration Guide Cisco IOS XE Everest 16.5.1 (Cisco ASR 900 Series)
30
Purpose
• Execute this command multiple times to accommodate the desired set of
VLANs. It works as append VLAN to the existing list instead of replacing
an existing one.
Enter this command only on the REP primary edge
Note
port.
Configures the number of retries permitted by LSL.
Configures the failure detection time.
• The valid range is from 120 to 10000. We recommend that you configure
the minimum range as 200 for better performance. While a lower value can
help improve performance, any changes to this command must be carefully
evaluated. Lowering the value indiscriminately may destabilize the system.
• (Optional) Configures a preempt time delay.
• Use this command if you want VLAN load balancing to automatically trigger
after a link failure and recovery.
• The time delay range is from 15 to 300 seconds. The default is manual
preemption with no time delay.
Use this command only on the REP primary edge
Note
port.
Returns to privileged EXEC mode.
(Optional) Displays the REP interface configuration.
• Enter the interface type and number and the optional detail keyword, if
desired.
(Optional) Saves your entries in the router startup configuration file.
Configuring Resilient Ethernet Protocol