Pairing With A New Remote; Connecting To The Remote - Recon MOD Live User Manual

3.4 Pairing with a new remote

Note: The remote and MOD and remote that come packaged together are already paired. To begin using the remote with
your MOD see section "3.5 Connecting to the Remote".
To pair MOD with a new remote different than the one your MOD was packaged, with follow these instructions:
1. Press and hold the left and right buttons on the remote until you see the LED flash blue and orange. The remote is
now ready to be paired with a new device.
2. Power on MOD and press any button on the new remote within 10 seconds.
3. If the new remote is detected, the following screen will appear listing the remotes that are currently in range.
The remotes are listed by their MAC address. The MAC address of your remote is written on the back.
4. Use the power button to move the cursor to the remote you want to pair with. Then wait 10 seconds and the
remote will pair.
You will be taken to the dashboard, and the remote icon in the status bar will turn solid blue:

3.5 Connecting to the Remote

Whenever you power on MOD, it will begin searching for a wireless remote. On start-up you will see this screen
Page 9 of 39