Table of Contents
Advertisement
View of the display is obstructed on one or more edges
1. MOD's optical module has been designed to be adjustable to the majority of facial types. If your view of the
screen is obstructed, adjust the optics arm of the MOD to find the ideal viewing position
2. Try tightening the strap to ensure the display is in view and MOD fits properly
MOD's battery runs out of charge sooner than expected
1. To prolong the battery life, power MOD off when not in use, lower the brightness, or use the DISPLAY OFF
feature.
2. MOD's battery can last Up to 8 hours at room temperature and Up to 6 hours at -10°C (14°F). Below -20°C (-
4°F) the battery life may be significantly impacted at temperatures lower than this. It is not recommended for
extended use at these lower temperatures
3. Ensure you properly charge the battery before using MOD. See "MOD fails to charge fully in 4 hours" for tips
on charging the battery.
Display frequently flashes white or is solid white
1. Connection from the board to the display may be loose or broken from mishandling or misuse. Contact
www.reconinstruments.com/support
Temperature displayed in MOD is too high/low
1. Like any thermometer, MOD's temperature sensor takes some time to adjust to the ambient air temperature.
The thermometer is located inside the wireless remote. For the thermometer to accurately measure the
outside air temperature, wear the remote on the outside of your body, instead of keeping in an inside pocket.
Cleaning the optic lens
1. Do not touch the optic lens with fingers or rough objects.
2. Always clean the optic with a soft cloth, lens cloth or goggle bag
3. Always store the MOD in an approved Recon-Ready goggle or in its original packaging to reduce the chance of
scratches
MOD has GPS fix but still displays "--" instead of valid speed
1. The dashboard speedometer displays "--"until it can calculate a valid speed from GPS data.
2. If the speedometer still displays "--" for more than a few minutes after the GPS indicator turns green, hold the
Power/Select button to power MOD off, then power back on
3. If the problem persists, contact
MOD is not recognized by my PC/Mac
1. Try unplugging the USB cable and plugging it back in
2. Hold the Power/Select button to power off. Plug MOD into PC/Mac and then hold the Power/Select button to
turn it on
3. Ensure you are using a high-power USB 2.0 port (not a USB port intended for keyboard)
MOD displays unusual or unreasonable statistics
1. Accuracy of statistics is affected by GPS reliability. For best performance, use MOD in open spaces with a clear
view of the sky
2. To reset statistics, navigate to "RESET STATS" in the Preferences menu and choose "YES" when prompted with
"SAVE AND RESET STATS?"
Page 30 of 39
for support information.
www.reconinstruments.com/support
for support
Advertisement
Table of Contents
