Table of Contents
Advertisement
Incorrect time on power Up after MOD has been in storage
1. If you have set the clock to local time, MOD will automatically remember the time every time you power it on.
However, if MOD has been in storage for many days without charging, the battery may drain completely and
shut off the internal clock. If this occurs, the clock will not be set properly after charging and powering Up
2. Simply set the time in the "SET TIME" screen under "PREFERENCES" if you encounter this problem
Display does not turn on
1. If the goggle has been powered off and stored in temperatures below -20°C (-4°F), the display may not
activate when powered on. Try warming Up the display by moving indoors, or by wearing MOD for 10 minutes
before turning on.
2. Try charging MOD using the Recon AC adapter for 1 hour, then attempt to power on.
3. Contact
www.reconinstruments.com/support
Chrono does not start after pressing the Power/Select button
1. The chrono needs to be reset before it can be started again. After you have stopped a chrono, use the
Power/Select button to reset it. The numbers should return to 0:00:00 and be coloured GREY.
2. To start a new chrono, press the Power/Select button again. The numbers will change colour to YELLOW and
the timer will begin counting.
Clock is adjusted automatically
1. MOD uses GPS time to automatically adjust the clock to the nearest time zone. This occurs immediately after
acquiring a GPS fix.
Display is too bright while viewing at night
1. You can adjust the display brightness in the "BRIGHTNESS" menu under "PREFERENCES". There are 3
brightness options: High, Med, and Low. Additionally, you can use the "DISPLAY OFF" feature to quickly
deactivate the display, while continuing to record to memory.
Altitude inaccuracy
1. MOD calculates altitude using a combination of air pressure and GPS data. When MOD is stationary, it adjusts
the altitude reading obtained from the pressure sensor to match the GPS reading. However air pressure can
change significantly with varying weather. This can cause altitude readings to be different from the actual
altitude.
2. If altitude is inaccurate after you have been in an open area for more than 30 minutes, try turning off the MOD
and turning it back on. The altitude reading should become more accurate within 10 minutes.
3. In general, clear weather will cause an increase in the displayed altitude, and stormy weather will cause a
decrease in the displayed altitude.
12. Safety, Storage, and Cleaning
MOD is a piece of electronics and should be handled safely, cleaned and stored properly. It is advised to handle MOD as if it
were an MP3 player or Smart Phone; protecting and charging in a safe place after use.
Put away dry and protected in a room-temperature location away from sharp and harmful, or magnetic items. Do not store
outside or exposed over night. Do not lay directly in the sun for long periods of time. Do not place items directly on top of
MOD. It is not advised to store or pack MOD for travel with other hardgoods such as skis or snowboards, or inside of ski and
snowboard bags.
Page 31 of 39
if problem persists
Advertisement
Table of Contents
