Table of Contents
Advertisement
Table Of Contents
Introduction ................................................................. 3
LED Status Light
Valet Switch
Remote Transmitter ................................................... 4-6
Active Arming
Silent Arming
Arming Bypass
Passive Last Door Arming ......................................... 5-6
The Armed System .................................................... 6-8
Disarming The System ............................................... 8
Disarming By Transmitter
Silent Disarming
Safety Disarm
The Valet Switch ........................................................ 9-12
Remote Panic ............................................................. 12-13
LED Status Light ........................................................ 13-14
Trunk Release
Optional Shock Sensor w/ Prewarn ............................. 15
Optional Sensor Remote Bypass
Programming Remote Transmitters .......................... 15-17
Programmable Features ............................................ 17-27
Features Programming Checklist .............................. 18
How to Program Features .......................................... 19-20
This feature's operation is the same as described in the previous
section, with the exception that it is activated by the opening of a door
while the ignition switch is on. Once the engine is running, if a door
is opened the valet switch must be pressed before 60 seconds
expires. Otherwise, the operation of this feature is identical to that
described for above for feature #25 "Ignition Activated Anti-Carjacking
Protection". This, the previous feature and #29 are independently
programmable, and any of them may be programmed to operate
alone or with the other two features.
#27 Open Door Warning Upon Arming: Default OFF. When this
feature is programmed to operate, if one of the vehicle's doors is open
when the system is armed using the remote transmitter, the horn will
chirp 3 times instead of once when arming the system with the
transmitter.
#28 PANIC Button Operates Additional Output: Default OFF.
This feature changes the remote transmitter's operation of the panic
feature and the additional output. With this feature is used, pressing
the transmitter's PANIC button for 2 seconds will operate the additional
output. The remote panic feature can still be operated, but changes
to pressing the LOCK button for 2 seconds to activate it. Once
activated, pressing the LOCK, UNLOCK or PANIC button will
deactivate the remote panic feature. Deactivating the remote panic
feature is the same regardless of whether the PANIC or LOCK button
is programmed to activate it. The remote panic feature's operation is
explained on page 12-13.
#29 Transmitter-Activated Anti-Carjacking Protection: Default
OFF. This feature will activate the Anti-Carjacking operation (see
feature #25) if the transmitter's LOCK and UNLOCK are pressed
together for 3 seconds while the ignition is on.
#30 Doorlock Outputs In "Add-on" Mode: Default OFF. This
feature is for the installer's benefit, allowing him to better interface the
UltiMate with the Omega Vehicle Tracking, Control and Notification
system.
Page - 27
Advertisement
Table of Contents
