Remote Panic - Omega Research & Development UltiMate Owner's Manual

may be made to achieve Selectable Code Override. See pages 20-
21 for further information on the Selectable Code Override.
Once the system is disarmed, if Valet Mode is desired, use the
Easy Valet TM procedure to place the system into Valet Mode.
Remember, if the Selectable Code Override factory setting of
"stage #1, one Valet Switch press and stage #2, no Valet Switch
press" is present, simply pressing the Valet Switch once within 10
seconds of turning the ignition switch on will override and disarm
the system.

Remote Panic

Your UltiMate system includes a remote Panic feature. In the
event of attack or assault, or any time you feel threatened or in need
of assistance, you can use your remote transmitter to activate this
feature. This feature operates regardless of the system's status, or
regardless of the ignition switch being on or off.
There are three forms of remote Panic operation:
- Pressing and holding the PANIC button for 3 seconds will
activate the Panic feature, sounding the horn, and flashing the
lights. Activating it with the PANIC button does not affect the
doorlocks- the system will only sound the horn and flash the
lights. Remote Panic can also be activated by pressing and
holding the LOCK or UNLOCK buttons.
- Pressing and holding the LOCK button will also activate the
Panic feature, but locking the doors in the process.
- Pressing and holding the UNLOCK button will also activate the
Panic feature, but unlocking the doors in the process.
Once remote Panic is activated, after 60 seconds, the system
will automatically stop and reset. If you wish to stop the Panic
feature during the 60 second period, press either the PANIC, LOCK
or UNLOCK button. When doing this:
- Pressing PANIC simply stops Remote Panic, without affecting
the system's prior armed or disarmed status, and without
affecting the doorlocks.
- Pressing LOCK to stop panic will leave the system armed with
locked doors, and pressing UNLOCK will leave the system
Page - 12
horn. If programming the maximum four transmitters, when the
fourth transmitter is acknowledged, the system will also exit the
transmitter programming mode.
For 48 hours after transmitters have been program-
med to operate the system, every time the ignition
switch is turned on, the horn will rapidly chirp for
two seconds and the LED Status Light will flash
the number of transmitters between pauses for 90
seconds. This is "Unauthorized Transmitter Alert".
In the event the system alerts you that transmitter have been
added without your knowledge, you should immediately reprogram
your own transmitters to the system, which will effectively erase any
unauthorized transmitters.
Programmable Features
Your UltiMate vehicle security system has thirty programmable
features. Many of these programmable features directly affect how
the UltiMate operates in daily operations, and thus are important to
the user as they allow for a wide range of customizing the system
to the user's needs and desires. The other few programmable
features are more related to the various installation parameters
presented by the wide range of vehicles; and their primary purpose
is to the installer, providing him efficient flexibility in properly
incorporating the UltiMate system into a specific vehicle applica-
tion.
As stated at the beginning of this guide, it thus far has described
the operations of the UltiMate system with all of the programmable
features set for the default settings. Should your system utilize any
of the programmable features, the following pages will have impor-
tant information describing further operations. Following is a list of
the programmable features, programming instructions, and then a
detailed description of each of the thirty programmable features.
Page - 17