Reboot Your Computer After Software Installation; Power Cord And Power Connection - Gamry Interface 1000 Operator's Manual

Chapter 3 -- Installation--Reboot your Computer after Software Installation
If you do not know how to navigate to the Gamry Installation device, consult your local computer expert or
network administrator or email techsupport@gamry.com.
Autorun.exe will run a Setup program. In most cases, you can choose the default choices or the most obvious
choices on all screens shown during the Setup process.
When the "Select Features" screen appears you will see a list of applications (eg DC105, PHE200, ESI300).
Make sure that you select all the applications that have been purchased with your system.

Reboot your Computer after Software Installation

You should reboot your computer once the Gamry Setup program is done. The Setup program will normally
offer you the opportunity to do so. USB device drivers are usually loaded when Windows boots up.
Following Setup, you may not be able to use your Interface 1000 until the drivers are loaded.
Device Driver Installation may not occur until a while after the Windows Desktop screen
appears. On a slow computer, or a busy computer with lots of applications, the delay
before driver installation can be a minute or more.

Power Cord and Power Connection

The Interface 1000 does not plug directly into the AC mains supply. Instead, the mains are connected to an
external power supply, which supplies a regulated 48-volt DC output. This regulated DC is then connected to
the DC power input jack on the rear of the Interface 1000.
The external power supply provided with the Interface 1000 is rated for operation from 100 to 240 V
frequencies from 47 to 63 Hz. It should therefore be useable worldwide.
The Interface 1000 external supply is normally supplied with a line cord suitable for use in the United States.
In other countries, you may have to replace the line cord with one suitable for your electrical outlet type. You
must always use a line cord with a CEE 22 Standard V (IEC 320 C13) female connector on the apparatus end
of the cable. This is the same connector used on the US standard line cord supplied with your Interface 1000.
The DC output cord from the external power supply plugs into the DC Power input jack on the rear panel of
the Interface 1000 (see Figure 3 - 2).
The output cable from the external power supply ends in a 3-pin miniature power DIN
male connector. This DIN connector cannot be plugged into either of the other DIN
connectors on the Interface 1000. Improper connection is therefore unlikely.
Note
Note
3 - 3
, at
AC