Adjusting sound quality and volume balance
Press
STEP
1
Pressing
STEP
2
About iPod
■
Apple is not responsible for the operation of this device or its compliance with
●
safety and regulatory standards.
iPod is a trademark of Apple Inc., registered in the U.S. and other countries.
●
iPod functions
■
When an iPod is connected and the audio source is changed to iPod mode, the
●
iPod will resume play from the same point in which it was last used.
Depending on the iPod that is connected to the system, certain functions may
●
not be available. If a function is unavailable due to a malfunction (as opposed to
a system specification), disconnecting the device and reconnecting it once
again may resolve the problem.
While connected to the system, the iPod cannot be operated with its own con-
●
trols. It is necessary to use the controls of the vehicle's audio system instead.
iPod problems
■
To resolve most problems encountered when using your iPod, disconnect your iPod
from the vehicle iPod connection and reset it.
For instructions on how to reset your iPod, refer to your iPod Owner's Manual.
Display
■
Up to 12 characters can be displayed at a time.
If there are 13 characters or more, pressing and holding
beep will display the remaining characters.
A maximum of 24 characters can be displayed.
If
is pressed until you hear a beep again or has not been pressed for 6 sec-
onds or more, the display will return to the first 12 characters.
Depending on the contents recorded, the characters may not be displayed prop-
erly or may not be displayed at all.
to enter iPod menu mode.
changes sound modes. (P. 274)
3-2. Using the audio system
until you hear a
3
261