Panasonic SP22P Operating Instructions Manual page 110

Rearrangement Position to Change the Mask Frame
A-1-4 For 600-by-550 Landscape Frame
Rearranging procedure
1 Set the support plate on reference side [ A ], sticking to the pin D at the center setting position.
(4 pieces of button bolts with hexagonal hole M4×8L)
2 Set the other plate [ B ] alike, and adjust the width for the mask added 7mm.
(4 pieces of button bolts with hexagonal hole M4×8L)
3 Set the Mask holder cylinder [ C ] to the position shown in the figure.
(2 pieces of bolts with hexagonal hole M5×75L and 6 pieces of bolts with hexagonal hole
M5×60L)
4 Set the positioning block 1 [ E ], sticking to the reference block.
(2 pieces of button bolts with hexagonal hole M4×12L)
5 Check the motion of mask detection sensor. (It lights after the mask frame is entered.)
2
153C-005P
Page A-6
3
5
Mask holder cylinder position
(4 points)
1
4
Pin D
193C-E-OMZ0A-A01-01