Bosch SHX89PW75N Operating Instructions Manual page 47

Fault Cause
Error code Drain pump blocked or cover on the
":Ġ is lit. drain pump is not locked in position.
Error code Supply voltage too low.
":ƒˆ is lit.
A different A technical fault has probably
error code is occurred.
indicated on
the digital dis-
play.
(":‹‚ to
":„‹)
Refill indicator No rinse aid.
for salt P
No salt.
and/or
Sensor does not detect salt tablets. Use different dishwasher softener salt.
rinse-aid H
is lit.
Refill indicator Refill indicator switched off.
for salt P
and/or
rinse-aid H
There is still enough special
is not lit.
salt/rinse aid available.
Water is left in Filter system or area under the fil-
the dishwasher ters 1b is blocked.
at the end of
Wash cycle has not ended yet.
the wash cycle.
* This is an optional feature which may or may not be included with your dishwasher.
Troubleshooting en-us
Remedial action
Clean pump and lock cover correctly.
~ "Drain pump" on page 45
Not a dishwasher fault, have the supply volt-
age and electrical installation checked.
Switch off dishwasher with the On/Off
switch (. After a short time restart the
dishwasher.
If the problem recurs, turn off the tap and
pull out the power supply plug.
Call customer service and mention the error
code.
Refill rinse aid.
Refill with dishwasher softener salt.
Activation/deactivation ~ ", Rinse Aid"
on page 18, ~ "+ Water softening
system / special salt" on page 16
Check refill indicator, levels.
Clean filters and area underneath.
Wait until wash cycle ends or reset.
47