Octal Label Kit Installation (For Plc Processors Only); Apply The Octal Filter Label; Apply The Octal Door Label; Removable Terminal Blocks - Allen-Bradley SLC 500 Installation Instructions Manual

Octal Label Kit Installation (for PLC processors only)

The octal label kit consists of an octal filter label and a door label. Use these octal labels to replace
the decimal labels that are attached to the I/O modules.
The octal label kit can be obtained from your Allen-Bradley distributor. The octal
TIP
kit is ordered based on the catalog number of the I/O module.
Please refer to the SLC 500 Modular Hardware Style User Manual, publication
1747-UM011, for a listing of octal label kit catalog numbers.

Apply the Octal Filter Label

1. Remove the octal filter label from its paper carrier.
2. Align the octal filter label numbers horizontally to the module color bar and over the
decimal filter numbers.
Refer to Installing Octal Labels on page 7
3. Apply the octal label to the filter.
4. Press firmly to be sure that the label adheres properly.

Apply the Octal Door Label

1. Remove the octal door label from its paper carrier.
2. Align the octal label directly over the decimal door label on the inside of the door.
Refer to Installing Octal Labels on page 7
3. Press firmly to be sure that the label adheres properly.

Removable Terminal Blocks

Colored terminal blocks are removable by loosening the upper and lower retaining screws. Black
terminal blocks are not removable.
Publication 1746-IN027D-EN-P - December 2012
www.aotewell.com
ATTENTION: Do not touch or remove the terminal block when the SLC 500 system is
powered. Contact with AC line potential may cause injury to personnel.
sales@aotewell.com
for filter label placement.
for door label placement.
Industry Automation
6 SLC 500 Digital I/O Modules
+86-755-8660-6182