Voicemail Setup - VTech DS3111-2 Manual

Telephone settings

Voicemail setup

This feature allows you to use the VOICEMAIL, PLAY, SKIP and ERASE
buttons to access your voicemail. Before completing these steps, be sure to
have your access number and password to access your voicemail available.
You will also need the key sequence to play, skip and delete your messages.
To program the ACCESS NUMBER button:
1. Press MENU/SELECT from the idle mode.
2. Press or to select VOICEMAIL SETUP, then press MENU/SELECT.
3. Press or to select ACCESS NUMBER, then press MENU/SELECT.
4. Use the dial pad to enter the access number. Press MUTE/REMOVE to
delete characters if necessary.
5. Press MENU/SELECT. You'll hear a confirmation tone.
To program the PASSWORD, PLAY, SKIP and ERASE buttons, follow the
above steps.
To program a pause:
1. Press MENU/SELECT from the idle mode.
2. Press or to select VOICEMAIL SETUP then press MENU/SELECT twice.
3. The blinking cursor should be at the end of your access number. Press and
hold the REDIAL/PAUSE button until a P appears.
4. Press MENU/SELECT. You'll hear a confirmation tone.
To reset all codes:
1. Press MENU/SELECT from the idle mode.
to select VOICEMAIL SETUP then press MENU/SELECT.
2. Press or
3. Press or to select RESET ALL CODES, then press MENU/SELECT.
4. The screen displays RESET CODES?
5. Press MENU/SELECT. You'll hear a confirmation tone.
DS3111-2 CIB 071607.indd 11
www.vtechphones.com
• A single pause
(approximately
three seconds)
is automatically
programmed
between the
>VOICEMAIL SETUP
access number
DIRECTORY
and the password
when you program
your VOICEMAIL
button so that your
>ACCESS NUMBER
voicemail service
PASSWORD
will recognize
your password.
Depending on your
voicemail service,
you may need to
program an extra
pause between
the access
number and your
password.
11
7/28/2007 5:55:43 PM