Curtis D1000GT12A000 User Manual page 13

PROGRAMMING GUIDE
Programming Options
Some menus save and exit automatically when a parameter is updated. Other menus exit to the previous menu
when a parameter is saved. To exit, press
Brew by Volume - adjusts the volume brewed (the factory default is 74 oz (2.2L). With an empty airpot in
place, press the appropriate BREW button. When the desired volume is reached, press the same BREW
button again to stop the brew cycle and set the volume.
Brew by Time - adjusts the amount of coffee brewed by time rather than by volume (the factory default is
3min-0sec). Once accessed, press
to change the number value. Press
to change the number value. Press
Temperature - sets the brewing temperature of the water held in the water tank (the factory default is 200ºF).
The range is 170ºF to 206ºF. Once accessed, press
to set and exit.
Energy Save Mode - saves energy during periods when the brewer is not in use (the factory default is
OFF). When set to ON, the brewer automatically shuts off two hours after the last brew cycle. Press the ON/
OFF button to return to normal operation. When set to ON 140ºF, the brewer shuts off two hours after the last
brew cycle, but the water tank temperature remains at 140ºF. Use the ON 140ºF setting to reach brewing
temperature faster after periods of non-use. Once accessed, press
Then press to set and exit.
Brew Count Odom - When accessed, this feature displays the total brew cycles since the odometer was last
reset. Press to exit or
Pre-Infusion - sets the brewer Pre-Infusion time (Pulse Brew must be off to access, the factory default is
Disabled). Pre-Infusion increases control of coffee clarity and extraction. When turned on, the range is 10 to 60
seconds. Once accessed, press
brew mode, choose 0 for the time.
When Pre-infusion is ON, Pulse Brew disappears from the list of menu items.
Brew Count Total - when accessed, displays the total brew cycles on the brewer. It cannot be reset. The
display returns to the previous screen automatically after a few seconds.
Cold Brew Lock - adjusts the temperature at which the brewer will brew coffee when the BREW button is
pressed (Ready to Brew appears on the display, the factory default is 5ºF). This feature also adjusts the
temperature at which the heating element turns on to reheat the water in the tank. The available settings
are 5°F, 15°F and OFF. OFF is within 30°F below the temperature setting. Once accessed, press
choose the desired setting. Then press
Master Reset - resets the brewer universal control module (UCM) to the factory default settings. Once
accessed, "Are You Sure?" will appear on the display. Press
Service Call - sets the service phone number that appears on the display when the UCM detects a SENSOR
ERROR or WATER ERROR . Once accessed, press
repeatedly to change the number value. Press
and press .
WC-785/WC-789, PROGRAMMING GUIDE
until EXIT appears on the display, then press
or
or
or
reset and exit.
or to choose the desired setting, then, press
to set and exit.
or
to exit.
or to choose the desired temperature. Then press
or to choose the desired setting.
for Yes or for No.
or to choose the number to be changed. Then press
to choose the next number to change or choose exit
PG8
.
repeatedly
repeatedly
to exit. To turn off pulse
or to
050217NC