Notes On Configuration And Operation; Modes And Communications Partners Of The Cp 1242-7 V2 - Siemens CP 1242-7 GPRS V2 Operating Instructions Manual

Notes on configuration and operation

Minimum clearance to the device
The device may only be operated when the distance between the device (or antenna) and
user is at least 20 cm.
NOTICE
Closing the front panels
To ensure interference-free operation, keep the front panels of the module closed during
operation.
5.1 Modes and communications partners of the CP 1242-7 GPRS V2
Modes and communications partners of the CP
For communication with the CP 1242-7 GPRS V2 via GPRS, the CP is set to one of the
following modes:
CP 1242-7 V2
Operating Instructions, 05/2014, C79000-G8976-C311-00
CAUTION
Telecontrol
This CP mode allows the GPRS station to exchange data with a telecontrol server.
The telecontrol server is a PC with the "TELECONTROL SERVER BASIC" application
that is connected to the Internet. It is generally located in the master station and is used
for monitoring and control of the remote GPRS stations.
Possible communications partners of the GPRS station with a CP 1242-7 GPRS V2 in
"Telecontrol" mode are:
– A telecontrol server
– A central control system (via the OPC interface of the telecontrol server)
– An engineering station (for TeleService)
– Up to 5000 GPRS stations with a CP 1242-7 GPRS V2 logged on with the telecontrol
server
You will find detailed information about the "TELECONTROL SERVER BASIC"
application in /2/ (Page 70), see References in the Appendix.
5
35