Table of Contents
Advertisement
Installing Fence Carriage to Jointer
1. Lossen the two cap screws attached on
the back of the jointer. Note-DO NOT
completely remove the cap screws.
2. Use an man assistant to hold the fence
carriage.
3. Line up two open holes on the fence carriage
with the two cap screws. (Fig. 4)
4. Attach the fence carriage to jointer, make sure
the surface of carriage level with jointer table
surface, tighten the cap screws.
Installing Fence to Fence Carriage
1. Lossen and take off the cap screw attached
on the fence holder.(Fig. 5)
2. Line up the hole on the fence and thread on
fence holder.(Fig. 5)
3. Connect these two parts with the cap screw.
And tighten it.
4. Lossen the two cone screws on the fence
carriage (A Fig. 6), line up with the two cone
nuts on the fence (B Fig. 6).
5. Tighten cone screws while adjusting the
flexibility of the fence by tilting th fence. When
the fence is secured and also preperly flexibe,
tighten the nut on cone screws(C Fig. 6).
8
Figure 4
Figure 5
Figure 6
Advertisement
Table of Contents
