Table of Contents
Advertisement
Installing Cutterhead Guard
1. Wind the tang the torsion spring back a
half turn, and slide the guard shaft into the casting
so the spring tang points tp the right and reset
against the casting.(Fig. 7)
2. Test the guard by pulling in back and
letting go.
-The guard should snap back over the cutterhead
without dragging across the table. If it does,
tighten the shaft lock.
-If the guard drags across the table, raise it until
it won't drag, then tighten the shaft lock.
-If the guard does not snap back, remove it and
repeat STEP 1&2, increasing the spring tension
as needed.
Installing Dust Chute
Attach the dust chute (Fig. 8) to the stand with
four screws and four flat washers, through the
pre-tapped holes in the stand.
Setting Outfeed Table Hight
Machine
disconnected from power source at this
time! Cutterhead blades are extremely sharp!
Use caution when hands are near the
cutterhead!
For most jointing operations, the surface of the
outfeed table must be level with the knife tips of
the cutterhead at
their highest
revolution. The knife tips must project equally
from the cutterhead.
The outfeed table and cutterhead are adjusted
at the factory and should not require adjustment.
However, it may change during the shipment, check
the outfeed table hight before use, if it is changed,
reset the outfeed table hight as following:
1. Place a strightedge(C Fig. 9) on the out-
table so it extends over the cutterhead.
should
be
point
of
10
Figure 7
Figure 8
Figure 9
Advertisement
Table of Contents
