Replacing Fuse For 220 - 240V - Makita DC24SA Technical Information

R
epair

(4) Replacing fuse for 220 - 240V

1. Remove damaged fuse from the receptacle, and replace the damaged one with new fuse.
Receptacles
(4A) Replacing fuse for 120 (See Fig. 13A.)
1. Remove damaged fuse from terminal with soldering iron.
2. Connect the wire of fuse to the terminal by soldering.
< Note > Be careful not to overheat the fuse with soldering iron. Otherwise the wire
of fuse may be cut with the heat of soldering iron.
Terminal
<9> When finish of repair, fasten circuit board complete to charger case
with 4 tapping screws 4 x 20.
And, do not forget to attach 4 caps 13.
Cap 13
Tapping
screw 4 x 20
(See Fig. 13)
Fuse for 220 - 240V
Fig. 13
Fuse for 120V
Fig. 13A
Fig. 14
P 7 / 8
Cap 13
Tapping
screw 4 x 20