Replacement Of Scirocco Fan; Replacement Of Terminal Cover; Assembling Terminal Unit - Makita DC24SA Technical Information

R
epair
<5> Replacement of scirocco fan
Disconnect the connector CN1 from circuit board complete and replace the broken scirocco fan with the new one.
(See Fig. 4.)
<6> Replacement of terminal cover
1. Remove the old terminal cover.
2. Attach torsion spring 14 on the new terminal cover as illustrated in Fig.5..
3. Hook the torsion spring 14 to the rib of charger case from its inside as illustrated in Fig. 6.
4. Hook the boss of terminal cover to the rib of charger case as illustrated in Fig.6.
Attach torsion spring
14 to the boss.
Fig. 5
<7> Assembling terminal unit
Insert compression spring 4 into the hole
of terminal base as illustrated in Fig. 7.
Insert 3 bosses of terminal unit into the holes
of terminal base as illustrated in Fig. 7.
Pass the lead wires of terminal unit
without slacking, along the portion marked
with .
Connector CN1
Terminal cover
Hook the torsion spring 14
to the rib of charger case
Compression spring 4
Terminal base
Scirocco fan
Terminal base
Band
Fig. 4
Fig. 6
Fig. 7
Hook the bosses
of terminal cover
to the rib of charger case
(Bottom view of charger case)
Terminal unit
P 5 / 8