UNB Tech CarSay UBC-100 User Manual page 7

3. How to use
2) Auto pairing mode
① press and hold
UBC-100 speaker and release it. And then, the Blue LED light will flash 3 times rapidly.
② When UBC 100 is turned on for the first time it will automatically try auto reconnection function ② When UBC-100 is turned on for the first time, it will automatically try auto reconnection function.
If the function, auto reconnection, is failed to activate then
Blue & Red LED light rapidly flash alternately, which then repeats "1) Pairing Mode" again.
(4) Set the mobile phone to search for all available Bluetooth (4) S t th bil h
When searching is complete, select "UBC-100" from the list of devices shown.
(5) Enter the passkey "0000" and press "OK" to pair
When pairing is successfully done When pairing is successfully done,
light will flash once every 10 seconds.
(6) If prompted by the phone to connect, select "Yes" (This will vary between phones).
UBC-100 is registered and paired with a Bluetooth
Once
Note Note
being deleted from the mobile phone, turned off, or out of the operation range, 10 meters(33 feet) from the mobile Phone.
About 5s
Power OFF Pairing Mode
(MFB) button for 2~4 seconds until you hear the indication tone of turning on from the
t h f ll il bl Bl
UBC-100 will make the short beep sound and then the Blue LED UBC 100 will make the short beep sound and then the Blue LED
Toot-toot
&
Power on Tone
UBC-100 will be in pairing mode as
t th devices around. d i d
® ® ® ®
UBC-100 with your mobile phone.
mobile phone, it will remain in the paired status unless
® ®
RED LED
BLUE LED
Indicate display Mobile search Complete