Table of Contents
Advertisement
10. Certification
FCC Notices
This device contains FCC ID: X3F-UBC-100 which complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference
( )
(2) This device must accept any interference received, including interference that may cause undesired operation.
p
y
"Exposure To Radio Frequency Radiation"
This device and its antenna must not be collocated or operated in conjunction with any other antenna or transmitter. To comply with FCC RF exposure
requirements, only use supplied antenna. Any unauthorized modification to the antenna or device could void the user's authority to operate this device.
CE 1177
This product is CE marked according to the provisions of the R & TTETTE Directive (99/5/EC). Hereby, UNB Tech, declares that this product is in compliance
p
with the essential requirements and other relevant provisions of Directive 1999/5/EC.
For further information please consult http://www.unbtech.co.kr
Within the EU this device is intended to be used in Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany,
Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, The Netherlands,
United Kingdom, and within EFTATA in Iceland, Norway and Switzerland.
Bluetooth
The Bluetooth® word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by U&B Tech is under license. Other trademarks and
trade names are those of their respective owners.
This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to part 15 of the FCC Rules. These limits are design
ed to provide reasonable protection against harmful interference in a residential installation
ed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio Frequenc
y energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no gu
arantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
▪ Reorient or relocate the receiving antenna.
▪ Increase the separation between the equipment and receiver
▪ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
© 2009 U&B Tech All rights reserved.
g
g
p
Daiyoung B/D 2
nd
Gyeonggi-Do, 431-807, Republic of Korea
Tel : +82-70-7137-3573
Fax : +82
www.unbtech.co.kr, www.carsay.co.kr,
y
p
(
)
y,
This equipment generates uses and can radiate radio Frequenc
FL, 1423-6, Gwanyang 1-dong, Anyang-city, Dongan-gu,
www.carkit.co.kr
,
p
p
Advertisement
Table of Contents
