Before Initial Use; Electrical Connection; Inserting The Batteries In The Remote Control - Silvercrest 113364 Operating Instructions Manual

Before initial use

GB
■
IE

Electrical connection

Inserting the batteries in the remote control

10
Remove all packaging materials and all transport locks from the appliance.
NOTE
► You may notice a slight smell when using the appliance for the first time.
This is normal and is completely harmless.
To ensure safe and trouble-free operation of the appliance after making the
electrical connection, please observe the following advice:
CAUTION
► Before connecting the appliance, compare the connection data (voltage
and frequency) on the rating plate with that of your mains power supply.
These data must agree so that no damage is sustained by the appliance.
► Ensure that the mains power cable is not damaged and is not running over
hot surfaces and/or sharp edges.
► Ensure that the mains power cable is not taut or knotted.
If the battery in the remote control
be inserted.
♦ Open the battery compartment
(see description on the rear of the remote control
♦ Remove the old battery from the remote control
NOTE
► Please follow the disposal instructions (see section Disposal of batteries).
♦ Insert a new CR2032 battery into the battery compartment
Ensure the +/- terminals are correctly aligned.
♦ Slide the battery compartment
is dead, a new CR2032 battery needs to
25
30 on the underside of the remote control
)
25
.
25
30 back into the remote control
.
25
30 .
.
25
SKD 2300 B2