ZiLOG ZENETSC0100ZACG User Manual page 9

cable's IP address, which can be obtained from ZDS II in the ZDS II
dow; see Steps 5 through 9
Observe the following steps to change the Ethernet Smart Cable's default settings:
1. Obtain the Ethernet Smart Cable IP address.
2. Open your web browser to the IP address located in Step 1. The Ethernet Smart Cable
home page will appear, as shown in Figure 6. The
access to the Ethernet Smart Cable's network settings. The
Figure 7, allows you to set a password for Ethernet Smart Cable access.
Figure 6. Ethernet Smart Cable Home Web Page
UM020705-1012
on page 4).
Ethernet Smart Cable
Project Settings
tab on this page provides
Settings
Password
User Manual
win-
tab, shown in
Page 9 of 13