Controlling Rip Reception And Advertisement On Interfaces; Configuring A Rip Version - HPE FlexNetwork 5510 HI Series Configuration Manual

Step
Enabling RIP on an interface
Step
Enter system view.
1.
Enable RIP and enter RIP
2.
view.
Return to system view.
3.
Enter interface view.
4.
Enable RIP on the interface.
5.

Controlling RIP reception and advertisement on interfaces

Step
Enter system view.
1.
Enter RIP view.
2.
Disable an interface from
3.
sending RIP messages.
Return to system view.
4.
Enter interface view.
5.
Enable an interface to
6.
receive RIP messages.
Enable an interface to send
7.
RIP messages.

Configuring a RIP version

You can configure a global RIP version in RIP view or an interface-specific RIP version in interface
view.
An interface preferentially uses the interface-specific RIP version. If no interface-specific version is
specified, the interface uses the global RIP version. If neither a global nor interface-specific RIP
version is configured, the interface sends RIPv1 broadcasts and can receive the following:
• RIPv1 broadcasts and unicasts.
Command
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
quit
interface interface-type
interface-number
rip process-id enable
[ exclude-subip ]
Command
system-view
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
silent-interface { interface-type
interface-number | all }
quit
interface interface-type
interface-number
rip input
rip output
29
Remarks
a single process, but does not
apply to multiple RIP processes.
Remarks
N/A
By default, RIP is disabled.
N/A
N/A
By default, RIP is disabled on an
interface.
Remarks
N/A
N/A
By default, all RIP-enabled
interfaces can send RIP
messages.
The disabled interface can still
receive RIP messages and
respond to unicast requests
containing unknown ports.
N/A
N/A
By default, a RIP-enabled
interface can receive RIP
messages.
By default, a RIP-enabled
interface can send RIP
messages.