Siemens Silver 3208XS Operating And Installation Instructions page 51

Transport
e.g. when moving
Preparing and inserting
the transport bolts
Before transporting the washing machine:
- Turn off the water tap,
- Drain any residual washing solution(refer to
Page 33),
- Release the water pressure in the supply hose
(refer to Page 34),
- Disconnect the washing machine from the mains,
- Dismantle the supply and drainage hose,
- Install the transport bolts.
Having transported the appliance and ensured
proper installation and connection, allow the
"Draining" program to run through before starting
the first wash program.
Remove the covers.
Preparing the transit bolt:
Pull the bolt out of the sleeve until the end of the
bolt is flush with the end of the sleeve.
Insert and tighten the bolts.
The lug on the washer must be located in the
groove in the rear panel of the housing.
49