Table of Contents
Advertisement
PNP/PCI Configurations
(C)2001 American Megatrends, Inc. All Rights Reserved
On Board Serial Port 3
Serial Port 3 IRQ
On Board Serial Port 4
Serial Port 4 IRQ
On Board Serial Port 5
Serial Port 5 IRQ
On Board Serial Port 6
Serial Port 6 IRQ
On Board Serial Port 1
On Board Serial Port 2
Serial Port 2 Mode
IR Pin Select
On Board Parallel Port
Parallel Port Mode
EPP Version
Parallel Port IRQ
Parallel Port DMA Channel
On Board IDE
On Board AC'97 Audio
Digital I/O Address
On Board Serial Port 1/2/3/4/5/6
This option specifies the base I/O port address of serial port. The settings are Auto (AMIBIOS
automatically determines the correct base I/O port address), Disabled, 3F8h, 2F8h, 2E8h, or
3E8h.
On Board Parallel Port
This option specifies the base I/O port address of parallel port on the motherboard. The settings
are Disabled, 378h, 278h, or 3BCh.
Parallel Port Mode
This option specifies the parallel port mode. The settings are Normal, Bi-Dir, EPP, and ECP.
Normal:
The normal parallel port mode is used.
Bi-Dir:
Use this setting to support bi-directional transfers on the parallel port.
EPP:
The parallel port can be used with devices that adhere to the Enhanced. Parallel Port
(EPP) specification. EPP uses the existing parallel port
asymmetric bi-directional data transfer driven by
ECP:
The parallel port can be used with devices that adhere to the Extended. Capabilities
Port (ECP) specification. ECP uses the DMA protocol to achieve data transfer rates up
to 2.5 Megabits per second. ECP provides
communication.
AMIBIOS SETUP – PERIPHERAL SETUP
3E8h
11
2E8h
10
2E0h
11
3E0h
10
3F8/COM1
2F8/COM2
Normal
IRRX/IRIX
378
Normal
N/A
7
N/A
Both
Enabled
280h
Figure 7: Peripheral Setup
Available Options:
Disabled
> 3E8h
2E8h
2E0h
3E0h
ESC:Exit
↑↓
PgUp/PgDn:Modify
F2/F3:Color
the host device.
symmetric bi-directional
34
:Sel
signals to provide
Advertisement
Table of Contents
