Setup Page - Digital Loggers Web Power Switch 7 User Manual

You may also Cycle a device which is connected to the controller.
This feature is useful for rebooting Ethernet devices which may
interrupt the web link to the controller. Clicking Cycle switches
power off, waits for the ON Delay time, and then switches power
back on. This reboots the attached device.
You can also cycle all outlets
using the Master Control on the
bottom of the page. An adjustable
ON sequence delay takes effect
when cycling, when using All
Outlets ON and on power-up.
Depending on your web browser settings, you may need to click
the Refresh button or F5 key to update the on-screen status
display after changing settings. Screen refresh rate is adjusted in
two places: on the Setup page and in your browser settings.

Setup Page

The Setup page allows the administrator to confi gure the power
controller. These settings are supported:
Controller and Outlet Names
Use the controller name fi eld to assign a Controller Name to the
power controller itself. Examples are Server Rack 4 PDU or
Phone Room Power Switch. The Controller Name appears on
top of all pages. Assign a separate name to each outlet, such as
DSL Router 1 or Backup Email Server to aid identifi cation. Check
the Confi rm button to the right of the outlet name if you would like
a pop-up window to appear before switching critical outlets.
Power-On Sequence Delay
When a time value is entered in the All ON Sequence Delay fi eld,
the power controller will pause for a period of time before switching
each outlet on in sequence. This delay helps prevent power
surges and blown circuit breakers which can occur when multiple
devices are switched on simultaneously. A delay of 60 seconds is
Web Power Switch 7 11