Ethernet using the web or a Password Security command line utility. Multi-user password security is provided to limit access to the power controller. The administrator selects which outlets each user controls. Web Power Switch 6 www.digital-loggers.com Web Power Switch 6...
3. Attach the cable from the controller to a port on your LAN. Switch power on. If you are connected to a switch, Web Power Switch 6 you may need to cycle power to the switch to establish a connection.
Access to specific outlets is match for earlier controllers and earlier firmware versions. Find the determined by your login. firmware revision history here. Web Power Switch 6 www.digital-loggers.com Web Power Switch 6...
Screen refresh rate is adjusted on option to do this. the Setup page. 3. You can return to the same outlet settings that were used prior to the power loss. The “All ON sequence delay” will Web Power Switch 6 www.digital-loggers.com Web Power Switch 6...
Page 6
To use AutoPing, first add an IP normal IP operation 10 minutes after reboot. address. Next, link that IP address to one or more outlets. Timing settings must be considered. Web Power Switch 6 www.digital-loggers.com Web Power Switch 6...
Since we’re constantly results and performance of the unit. DLI warrants this power controller to be adding and changing features, specifications are subject to change without notice. ETHERNET POWER CONTROLLER II Web Power Switch 6 www.digital-loggers.com Web Power Switch 6...
Need help?
Do you have a question about the Web Power Switch 6 and is the answer not in the manual?
Questions and answers