Monitor Setup; Initial Setup - Masimo RAD-57C Operator's Manual

3
M o n i t o r S e t u p

INITIAL SETUP

1. Inspect the oximeter case for damage.
2. Install 4 (four) new AA alkaline batteries.
3. Turn the device on, the LEDs will scroll in the display window as the sensor
4. Configure the device for your regional power line frequency (50 or 60 hz) if needed.
CAUTION: THE DEVICE MUST BE CONFIGURED TO MATCH YOUR LOCAL POWER
No other setup is required. Refer to Section 4, General Setup and Use for additional steps
to verify proper functioning of the device.
3-2
calibrates, verify all indicators illuminate and speaker sounds a brief tone.
Default is 60 hz (standard for the United States). See Section 4, Special Menu,
Special menu - Line Frequency Configuration.
LINE FREQUENCY TO ALLOW FOR THE CANCELLATION OF NOISE
INTRODUCED BY FLUORESCENT LIGHTS AND OTHER SOURCES.
Rad-57 Signal Extraction Pulse CO-Oximeter Operator's Manual
s e t u p