Wideye Sabre Shield Installation Manual page 6

6 Preparing the SABRE™ Shield
Follow these steps to prepare the SABRE™ Shield:
1. Place the SABRE™ Shield on a flat surface.
2. Release the four cover screws and remove the cover.
Cover
screws
Multi-function
cable connector
3. Release the velcro-tape securing the Multi-function cable.
4. Remove the Multi-function cable from the SABRE™ Shield.
5. Remove the pack of screws, bolts, nuts and washers from the SABRE™ Shield
and keep them in a safe place.
5
SABRE TM Shield Installation Guide
Cover
Screws
Cover
Multi-function
cable