Table of Contents
Advertisement
English
The temperature value is one of the most influential parameters for the ecosystem of an
aquarium.
Therefore, it becomes indispensable to measure, and if possible, control it by using heat-
ers and coolers.
Another particularly useful accessory is the mechanical level sensor. This accessory verifies
the presence of water in a tank, or as it is more often used, in an external filter (SUMP),
in order to activate an automatic topoff.
Aquatronica recommends the product "Temperature & Level Interface" which makes it
possible to connect additional temperature and level sensors to the "Aquarium Control-
ler" system.
Pack contents
You will find:
•
One Temperature/Level probe connection interface.
•
One BUS cable for connecting the interface to the power unit
LEVEL SENSOR
TEMPERATURE
SENSOR
NOTE: it is possible to indifferently connect two temperature sensors, two level
sensors, or even one of each.
1.
Connect the probe's connector to the interface (ACQ210-TL).
2.
Connect the ACQ210-TL interface to the power unit (or HUB) using the provided
BUS cable.
NOTE: Insert the correct end of the connector into the power unit; inserting it in
the other direction can seriously damage the equipment.
IsACQ210TL-2 Rev. 240907-2
Via dell'Industria, 20 - 42025 Cavriago (RE) Italy Tel.: +39 0522 494403
Fax: +39 0522 494410 http:\\www.aquatronica.com E-mail: service@aquatronica.com
Connection Diagram
ACQ210-TL
3 - 8
Advertisement
Table of Contents
