Settings - Mercedes-Benz COMAND Operating Instructions Manual

360° camera
50
Call up the seat functions (
X
To select Seat Heating Balance Seat Heating
X
and press the controller.
To select a seat: slide 1 the controller.
X
To change the setting: turn the controller.
X
You will see the changes you have made in
the settings display.
The settings represent the following:
0 0 — the backrest and seat cushion are
R
evenly heated according to the setting
selected with the seat heating button.
1 1 to 3 3 — the heat output to the seat cushion
R
is reduced one level at a time.
-1 -1 to -3 -3 — the heat output to the backrest is
R
reduced one level at a time.
To exit the menu: press the % button.
X
Resetting all adjustments
Call up the seat functions (
X
Select a seat.
X
To select Reset Reset: turn and press the con-
X
troller.
To select a seat: slide 1 the controller.
X
To reset: press the controller.
X
A prompt appears.
To select Yes Yes
X
troller.
If you select No No
After selecting
reset to the default values (factory setting).
360° camera
General notes
The 360° camera is only an aid. It is not a
replacement for your attention to your imme-
diate surroundings. You are always responsi-
ble for safe maneuvering and parking. Make
sure that no persons or animals are in the
maneuvering range.
page 48).
Y
Balance: turn
page 48).
Y
or No: turn and press the con- No
the process is canceled.
Yes Yes all seat adjustments are
Overview
The 360° camera surveys the vehicle sur-
roundings and assists you, for example when
parking or at exits with reduced visibility.
Further information on the 360°camera can
be found in the vehicle Operator's Manual.
Settings for the 360° camera
When you activate the
gear gear function, the image from the 360° cam-
era is displayed when you select reverse gear.
Activating/deactivating using the reverse
gear:
Press the Ø button on the COMAND
X
control panel.
or
Press Vehicle Vehicle in the main function bar.
X
The vehicle menu is displayed.
To switch to the menu bar: slide 6 the
X
controller.
To select System Settings System Settings: turn and
X
press the controller.
Select 360° 360° Camera Camera.
X
Select Activation by R gear Activation by R
X
The function is switched on O or off ª,
depending on the previous status.
Opening the camera cover for clean-
ing
To select Open Camera Open Camera Cover
X
camera menu: turn the controller and press
to confirm.
The Please Wait... Please Wait...
approximately three seconds.
The camera cover opens.
The camera cover closes automatically if:
the ignition is switched off
R
the vehicle exceeds a speed of approx.
R
30 km/h
Activation by R Activation by R
gear.
Cover in the 360°
message appears for