Craftsman 31017 Operator's Manual page 3

operatioN
iNstaLLiNG DraWers
Ball bearing slide - Pull slides and slide carrier out to fully
extended position (see illustration). Hold the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its fully closed position to engage slide. Open
drawer and reclose to ensure proper operation.
slide carrier
removiNG aND iNstaLLiNG sLiDes
• To remove the slide from the unit, first remove the
drawer.
• After removing the drawers drill out the rivets, use a
5/32-in drill bit. The rivets will need to be replaced.
• To reinstall the slide, place the slide in the appropriate
position in the unit and pull toward the front of the unit.
Replace rivets to secure slide to the unit.
• For smooth operation, make sure the drawers are
matched with their original slides.
Drill out rivet
slide
removiNG aND iNstaLLiNG sLiDes from uNit
• First remove the drawer. (See section A)
to remove the slide:
• Push slide to the closed position.
• Insert flat tip screwdriver between slide and unit, behind rear
rectangular cutout.(See illustration).
• Rotate screwdriver ¼ turn to force slide away from unit.
• Push on front of slide pushing it towards back of the unit.
to attach the slide:
• Extend slide and locate lances within respective
cutout in carrier.
• Pull slide forward until slide locks back into place.
• Reinstall drawer following drawer installation proce-
dure.(See section B)
to LocK cHest
• Insert the lockbar (which stores in the top tray), tabbed
end up, into the slot in the top tray and down into the slot
in the base. Close the cover and lock with the key.
to LocK roLL-aWay
• The lockbar for the roll-away is stored in a slot in the top
front corner of the unit.
• Insert the straight end of the lockbar into the slot in the
base.
• Move the lockbar toward the unit until the bent end fits
into the slot near the lock. Lock with the key.
paNeL
• If your unit is equipped with a storage compartment with
a panel at the bottom, pull panel out, lift up and push
panel back into unit to gain access to compartment.
3