Speaker Connection - GAS Car Audio COMPETITION 7000.1D Owner's Manual

Speaker connection

(COMPETITION 7000.1D / COMPETITION 12000.1D)
SINGLE CONNECTION
SPEAKER
OUTPUTS
Speaker Impedance
1~8 ohms
DAISY CHAIN (LINKED) CONNECTION
MASTER
SPEAKER
AMPLIFIER OUTPUTS
Speaker Impedance
2~8 ohms
SLAVE
SPEAKER
OUTPUTS
AMPLIFIER
Daisy chain connection allows linking of 2 same amplifiers to work as 1 single amplifier.
Please read the following connection diagram cautiosly to ensure the correct connection.
Step 1. Connect the master amplifier to the head unit and set its output master
and input slave switch to output master position (
Step 2. Connect the master and slave amplifier in daisy chain RCA jack as shown in the diagram.
Step 3. Set slave amplifier output master & input slave switch to slave input position (
Step 4. Connect speaker cable (+) on master amplifier to subwoofer (+)
Step 5. Connect speaker cable (+) on slave amplifier to subwoofer (-)
Step 6. Connect speaker cable (-) on master amplifier to speaker cable (-) on slave amplifier using 8 AWG wire cable.
The minimum impedance as 1 unit is 1
In a daisy chain configuration the minimum impedance is 2
SUB BASS BASS PHASE
REMOTE
SONIC BOOST FREQ. SHIFT
GAIN LPF
10V 0.2V 10Hz 70Hz 0dB 12dB 30Hz 90Hz 30Hz 250Hz 0 180
INPUT OUTPUT
CH1 CH2 CH1 CH2
HEAD UNIT
SUB BASS BASS PHASE
REMOTE
GAIN SONIC BOOST FREQ. LPF SHIFT
10V 0.2V 10Hz 70Hz 0dB 12dB 30Hz 90Hz 30Hz 250Hz 0 180
INPUT OUTPUT
CH1 CH2 CH1 CH2
HEAD UNIT
SUB BASS BASS PHASE
REMOTE
SONIC BOOST FREQ. SHIFT
GAIN LPF
10V 0.2V 10Hz 70Hz 0dB 12dB 30Hz 90Hz 30Hz 250Hz 0 180
INPUT OUTPUT
CH1 CH2 CH1 CH2
)
MASTER
SLAVE
.
8
PWR
PRT
SLAVE
MASTER SLAVE
MASTER
OUTPUT INPUT
DAISY-CHAIN
PWR
PRT
SLAVE
MASTER SLAVE
MASTER
OUTPUT INPUT
DAISY-CHAIN
PWR
PRT
SLAVE
MASTER SLAVE
MASTER
OUTPUT INPUT
DAISY-CHAIN
)
.