Panel Layout - GAS Car Audio COMPETITION 7000.1D Owner's Manual

Panel Layout

(COMPETITION 7000.1D / 12000.1D)
SPEAKER
OUTPUTS
1) INPUT
Connect preamp signal cables from head unit to RCA input of amplifier.
Minimum level input of 0.2V is essential for correct operation.
2) OUTPUT
Output RCA for signal routing to another amplifier.
3) GAIN (10V ~ 0.2V)
Matches the output voltage of the head unit's RCA line-outs to the input section.
4) SUBSONIC FILTER (10Hz ~ 70Hz @ 24dB OCTAVE SLOPE)
Control the high pass point for the speaker outputs to eliminate xtreme low frequencies.
5) LOW PASS FILTER (30Hz ~ 250Hz @ 24dB OCTAVE SLOPE)
Controls the low pass points for speaker outputs.
6) BASS BOOST
Variable bass boost with 0-12 dB @ 30Hz ~ 90Hz.
7) PHASE CONTROL
Variable phase adjustment from 0~180 degrees
8) REMOTE LEVEL CONTROL PORT
Used for connecting to external wired remote controller.
9) REMOTE CONTROL (OPTIONAL ITEM)
Turn knob clockwise to increase level and likewise, turn knob counter clockwise decrease level.
10) MASTER OUTPUT / SLAVE INPUT
For linkable connection of 2 same amplifiers. Minimum impedance is 2
In this mode, the master amplifier will control gain settings on the subsequent slaved amplifier.
11) POWER & PROTECTION INDICATOR
Power LED, green-lit or blue-lit shows correct operation. Protect LED, Red-lit shows general malfunction,
faulty connection or thermal protection.
10) SPEAKER OUTPUTS
Amplifier connection to loudspeakers. Minimum size of speaker cable is 12 gauge.
Minimum impedance for single unit is 1
Minimum impedance in linked connections is 2
SUB BASS BASS PHASE
REMOTE
SONIC BOOST FREQ. SHIFT
GAIN LPF
10V 0.2V 10Hz 70Hz 0dB 12dB 30Hz 90Hz 30Hz 250Hz 0
INPUT OUTPUT
CH1 CH2 CH1 CH2
.
.
4
PWR
PRT
180
SLAVE
MASTER SLAVE
MASTER
OUTPUT INPUT
DAISY-CHAIN
.