GAS Car Audio COMPETITION 7000.1D Owner's Manual page 7

+12V (B+ ), GND, REM Connection
(COMPETITION 12000.1D)
SINGLE CONNECTION
POWER POWER
INPUT-B INPUT-B
Remote turn on
HEAD UNIT
DAISY CHAIN (LINKED) CONNECTION
POWER POWER
INPUT-B INPUT-B
Remote turn on
HEAD UNIT
Remote turn on
POWER POWER
INPUT-B INPUT-B
Keep GROUND of equal length. This drawing is for illustration purposes only.
We recommend using 12 AWG speaker cables to obtain intended performance.
Run 12 AWG speaker cables from your speakers to the amplifier's mounting location
Keep the speaker cables separate from the power cables and and the amplifier's input cables.
Use grommets where the cables have to penetrate the vehicle chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 1cm, 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause short circuit.
Connect the cable ends to the amplifier as shown in the speaker wiring diagram.
GND GND +12V +12V +12V +12V REM REM
PT LINK PT LINK
GND GND +12V +12V +12V +12V REM REM
PT LINK PT LINK
GND GND +12V +12V +12V +12V REM REM
PT LINK PT LINK
CAUTION
7
GND GND +12V +12V GND GND
POWER POWER POWER POWER
INPUT-A INPUT-A INPUT-C INPUT-C
Recommended Fuse Rating
(See page 10)
GND GND +12V +12V GND GND
POWER POWER POWER POWER
INPUT-A INPUT-A INPUT-C INPUT-C
Recommended Fuse Rating
(See page 10)
GND GND +12V +12V GND GND
POWER POWER POWER POWER
INPUT-A INPUT-A INPUT-C INPUT-C
GROUND
BATTERY
GROUND
BATTERY