GAS Car Audio COMPETITION 7000.1D Owner's Manual page 5

+12V(B+), GND, REM
(COMPETITION 7000.1D)
POWER INPUT A
(COMPETITION 12000.1D)
POWER POWER
INPUT-B INPUT-B
GND (GROUND CONNECTION)
For connection to chassis ground. For optimum performance, 0 gauge cable is recommended.
REM (REMOTE)
Connect to switched +12V from the head unit.
+12V / B+ (POWER CONNECTION)
For connection to positive terminal of battery (+12).
For optimum performance, 0 gauge cable is recommended.
PT Link
If you link two same amplifiers as master and slave connection, then connect the 2 amplifies using
the PT Link cable provided. In case when the master unit enters into protection, the slave unit will also
enter into protection thereby protecting the slave unit from unexpected damage.
Before attempting to make any connections to power supply, input and output connectors,
make sure the amplifier is in OFF state. Check polarity of cables carefully as using reversed
polarity will cause damage to amplifier. And to prevent power loss and overheating of wiring,
always use the recommended wire gauges.
Installation of the amplifier should be done in the following steps:
1. Ensure that the ground is appropriate, then connect it to the amplifier.
2. Next step is to connect the +12V wire. Ensure all power terminals are used.
This cable has to be fused at the battery for safety precautions.
3. The final step is connecting the switched remote.
GND REM +12V
PT LINK
GND GND +12V +12V +12V +12V REM REM GND GND
PT LINK PT LINK
CAUTION
CAUTION
5
+12V GND
POWER INPUT B
+12V +12V GND GND
POWER POWER POWER POWER
INPUT-A INPUT-A INPUT-C INPUT-C