Single Connection - GAS Car Audio COMPETITION 7000.1D Owner's Manual

+12V (B+ ), GND, REM Connection
(COMPETITION 7000.1D)

SINGLE CONNECTION

POWER INPUT A
Remote turn on
HEAD UNIT
DAISY CHAIN (LINKED) CONNECTION
POWER INPUT A
Remote turn on
HEAD UNIT
Remote turn on
POWER INPUT A
Keep GROUND of equal length. This drawing is for illustration purposes only.
We recommend using 12 AWG speaker cables to obtain intended performance.
Run 12 AWG speaker cables from your speakers to the amplifier's mounting location
Keep the speaker cables separate from the power cables and and the amplifier's input cables.
Use grommets where the cables have to penetrate the vehicle chassis.
Connect the speaker wires according to the terminals on each speaker.
Strip 1cm, 3/8" of insulation of the end of each cable and twist the cables strands together tightly.
Make sure there are no stray strands that might touch other cables or terminals and cause short circuit.
Connect the cable ends to the amplifier as shown in the speaker wiring diagram.
GND REM +12V
PT LINK
GND REM +12V
PT LINK
GND REM +12V
PT LINK
CAUTION
6
+12V GND
POWER INPUT B
Recommended Fuse Rating
(See page 10)
+12V GND
POWER INPUT B
Recommended Fuse Rating
(See page 10)
+12V GND
POWER INPUT B
GROUND
BATTERY
GROUND
BATTERY