Reference Mode; How To View And Set The Frequency Reference - ABB ACS150 series User Manual

64

Reference mode

In the Reference mode, you can:
• view and set the frequency reference
• start, stop, change direction and switch between local and remote control.

How to view and set the frequency reference

You can set the local frequency reference with the integrated potentiometer in any
mode when the drive is in local control if parameter
the default value 0 (POT). If parameter
to 1 (KEYPAD), you have to set the local frequency reference in the Reference
mode.
You can view the current local reference in the Reference mode only.
Step Action
1. Go to the Main menu by pressing
otherwise by pressing
2. If the drive is in remote control (REM shown on the left), switch to local
control by pressing
to local control.
Note: With group
remote (external) reference in remote control (REM) for example, using the
integrated potentiometer or keys
3. If the panel is not in the Reference mode ("rEF" not visible), press key
or
shows the current reference value with
4. If parameter 1109
• To increase the reference value, rotate the integrated potentiometer
clockwise.
• To decrease the reference value, rotate the integrated potentiometer
counterclockwise.
The new value (potentiometer setting) is shown on the display.
If parameter 1109
• To increase the reference value, press
• To decrease the reference value, press
The new value is shown on the display.
Control panel
if you are in the Output mode,
repeatedly until you see MENU at the bottom.
. The display briefly shows "LoC" before switching
LOC
REM
11 REFERENCE SELECT, you can allow changing of the
and
until you see "rEF" and then press
SET
LOC REF SOURCE = 0 (POT, default):
LOC REF SOURCE = 1 (KEYPAD):
1109 LOC REF SOURCE has been changed
.
. Now the display
under the value.
.
.
1109 LOC REF SOURCE has
Display
PAr S
REM
MENU
PAr S
LOC
MENU
rEF
LOC
MENU
49
LOC
50
LOC
50
LOC
FWD
FWD
FWD
1
.
Hz
SET
FWD
0
.
Hz
SET
FWD
0
.
Hz
SET
FWD