STEP 8
Attach chair left and right front legs (G & H) to seat frame (F) with flat
washers (3), spring washers (2), and nuts (8) as shown. Do not fully tighten
nuts (8). Insert chair left side crossbar and chair right side crossbar (J)
into the front left and right chair legs (G & H) and chair back frame (D).
Note: The small holes on all the crossbars must face towards the ground
(when chair in the normal use position).
Tighten all nuts previously installed with wrench (9). Secure the front
crossbar (I), chair left side crossbar (J) and chair right side crossbar (J) to
the chair legs using wood screws(7) and a Phillips head screw driver
(not included) as shown below.
REQUIRED HARDWARE IN THIS STEP
DESCRIPTION
NO.
8.
NUT
2.
SPRING WASHER
3.
FLAT WASHER
OPEN WRENCH
9.
7.
WOOD SCREW
7
SKETCH
QTY
4 PCS
4 PCS
4 PCS
1 PC
6 PCS