Attaching The Shoulder Belt - Makita DCL501 Instruction Manual

If the appliance does not start, the battery
is overheated. In this situation, let the
battery cool before restarting the
appliance.
• Low battery voltage:
The remaining battery capacity is too low
and the appliance will not operate. In this
situation, remove and recharge the
battery.
Installing or removing
attachments
CAUTION:
• Always be sure that the appliance is
switched off and the battery cartridge is
removed before carrying out any work on
the appliance.
• Firmly push the nozzle or zoom pipe into
the handle while twisting to securely attach
to ensure that they do not come loose
during use.
Attach the hose connector to the suction
hose opening on the appliance.
Press the release button to disconnect the
hose.
1
2
Insert the zoom pipe into the end of the
handle.
1
2
Loosen the zoom pipe ring and adjust the
pipe length. After adjustment, tighten the
ring.
1
6
1. Release button
2. Suction hose
opening
1. Handle
2. Zoom pipe
1. Ring
Attach the nozzle to the zoom pipe.
Attach the crevice nozzle to the handle or
zoom pipe to use to clean crevices and other
narrow, hard-to-reach areas.
1
CAUTION:
• Do not cover the hole of the crevice
nozzle. It may cause overheat and result in
damage to the appliance.

Attaching the shoulder belt

CAUTION:
• When hanging the appliance on your
shoulder, always hold the appliance itself
by hand to prevent it from dropping.
Dropping the appliance may cause injury
or property damage.
Use the shoulder belt to hang the appliance
on your shoulder for cleaning a high place.
Loop the shoulder belt around both the
carrying handle and the belt holder and then
run it through the stopper as shown in the
diagram.
1. Nozzle
1
1. Crevice nozzle