Kashino Technology P-500 User Manual page 27

0≤x≤12 (when Font A (12×24) is selected)
0≤d1 ... d(y×xk) ≤255
Defines user-defined characters.
[Description]
y specifies the number of bytes in the vertical direction.
c1 specifies the beginning character code for the definition, and c2
specifies the final code.
x specifies the number of dots in the horizontal direction.
[Note] The allowable character code range is from ASCII code <20>H to
<7E>H (95 characters).
It is possible to define multiple characters for consecutive character
codes. If only one character is desired, use c1=c2.
d is the dot data for the characters. The dot pattern is in the horizontal
direction from the left side. Any remaining dots on the right side are
blank.
The data to define user-defined characters is (y×x) bytes.
Set a corresponding bit to 1 to print a dot or 0 not to print a dot.
This command can define different user-defined character patterns for
each font. To select a font, use ESC !
User-defined characters and a downloaded bit image cannot be
defined simultaneously. When this command is executed, the
downloaded bit image is cleared.
The user-defined character definition is cleared when:
1）ESC @ is executed.
2）GS * is executed.
3）ESC ? is executed.
4）The power is turned off.
The internal character set
[Default]
ESC %, ESC ?
[Reference]
[Example]
When Font A (12×24) is selected.
Page 27 of 70