Kashino Technology P-500 User Manual page 23

ESC SP n
[Name] Set right-side character spacing
[Format] ASCII:
Decimal:
Hexadecimal:
[Range] 0≤n≤255
[Description] Sets the character spacing for the right side of the character to [n×0.125
mm (n×0.0049")].
[Note] The right-side character spacing for double-width mode is twice the
This command does not affect the setting of Kanji characters
This command sets values independently in standard mode.
[Default] n=0
ESC SO n
[Name] Select Double Width mode
[Format] ASCII:
Decimal:
Hexadecimal:
[Description] Select Double Width mode
To turn double width off, use LF or DC4 command.
ESC DC4 n
[Name] Disable Double Width mode
[Format] ASCII:
Decimal:
Hexadecimal:
[Description] Disable Double Width mode
ESC { n
[Name] Turns on/off upside-down printing mode
[Format] ASCII:
Decimal:
Hexadecimal:
[Range] 0≤n≤255
[Description] Turns upside-down printing mode on or off.
When the LSB of n is 0, upside-down printing mode is turned off.
When the LSB of n is 1, upside-down printing mode is turned on.
[Note] Only the lowest bit of n is valid.
normal value. When characters are enlarged, the right-side character
spacing is n times normal value.
Page 23 of 70
ESC SP n
27 32 n
1B 20 n
ESC SO n
27 14 n
1B 0E n
ESC DC4 n
27 20 n
1B 14 n
ESC { n
27 123 n
1B 7B n