Miele CM5300 Operating Instructions Manual page 64

Problem solving guide
Problem
Empty the drip tray and the
appears
waste container
in the display, even
though the drip tray has
been emptied.
Insert the drip tray and the
appears
waste container
in the display even
though both are fitted.
The drip tray or waste
container is full or
overflowing, although
they have been emptied
following each
reminder.
Fill the bean container
appears in the display
even though the bean
container has just been
filled.
The coffee machine
does not rinse itself
when turned on.
64
Cause and remedy
The drip tray is not positioned correctly in the
machine.
 Push the drip tray in as far as it will go.
 Make sure that the lower panel is sitting on the
drip tray correctly.
The drip tray is not in the correct position and is
therefore not detected.
 Empty the drip tray and the waste container.
Reassemble all parts and push the drip tray back
as far as it will go in the coffee machine.
This is not a fault.
The drip tray and waste container were probably
removed or the machine was opened without the drip
tray and waste container being emptied. When the
drip tray is removed or the machine opened, the
internal counter for emptying the drip tray and waste
container is automatically reset.
 Remove the drip tray and waste container from the
machine and empty them.
This is not a fault.
 Confirm the message with OK.
Insufficient coffee beans are getting into the grinder.
Have you used a dark roast?
This type of coffee bean is often more oily. These oils
can cling to the inside of the coffee bean container
and hinder the flow of beans.
 Make a coffee and observe whether the coffee
beans drop into the coffee bean container.
 Clean the coffee bean container more often if you
are using a darker, more oily bean.
Try other types of coffee bean which are less oily.
This is not a fault.
If the coffee machine is already at operating
temperature, rinsing will not take place.