Installing The Rru On A Wall - Huawei RRU3268 Installation Manual

RRU3268
Installation Guide

8.5 Installing the RRU on a Wall

This section describes the procedure and precautions for installing the RRU on a wall.
Prerequisites
The hoist clamp on the main bracket is secured properly.
l Do not stand the RRU upright because the RF ports cannot support the weight of the RRU.
l Place a foam pad or cardboard under the RRU to protect the RRU housing from damage
Context
The wall on which RRUs are installed must meet the following requirements:
l
l
Procedure
Step 1 Disassemble the RRU mounting brackets, as shown in
Issue 10 (2015-12-30)
NOTICE
during the installation.
For each RRU, the wall must be able to bear a weight four times the RRU's weight and
the bolts' pulling force of 1.25 kN (281.25 lbf) vertical to the wall.
Expansion anchor bolts must be tightened to 30 N·m (265.52 lbf·in.) so that the bolts
stay secured without damaging the wall.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Installing the RRU
Figure 8-36.
71