Configuring The Z-2400-A2R - Intech Z-2400-A2R Installation Manual

Configuring the Z-2400-A2R:

With the Z-2400-A2R repeater node, there are only two parameters to configure: the 'Mesh ID' and the
'Wireless Transmit Power'. Because the repeater is sold separate to the Input & Output nodes, it requires the Mesh ID
pairing with your Input/Output Z-2400-A2 wireless set.
Z-2400-A2R Overview
Remember to ALWAYS click the 'Apply' button after you change any settings, this will program the
new settings to your Z-2400-A2R node.
Mesh ID: This step will require you to copy the unique Mesh ID
from your Z-2400-A2O Output node. This can be found by
Connecting the Output node to the uP Configure software and
copying the 16 digit Mesh ID number from the 'Overview' screen
(as shown on page 10 of the Z-2400-A2IO Installation Guide).
After you have then properly connected the repeater node to
your PC and have the 'Overview' screen up, click on the 'Edit'
button next to the Mesh ID number, and then type in the Mesh
ID number exactly as you have copied down from the Output
node.
Wireless Transmit Power:
Next click on the drop down menu as shown and select your
region. This setting is important and must be set to comply
with the wireless standards of your area.
To disconnect the Z-2400-A2R node from your computer, click on 'Disconnect?' in the
top right corner of the screen.
9