Table of Contents
Advertisement
Power and ZigBee Network LED indication.
PWR
STACK
NTWRK STATUS 1, 2
ZigBee Mesh ID.
The reason for Mesh IDs is to allow for multiple wireless Bases (Z-2400-A2O, Z-2400-RB & Z-2400-TCP) and therefore
networks to be used in the same location where the mesh signals will overlap. You can program the Mesh ID of the
Repeater node via the 'uP Configure' software. The Input and Output nodes are supplied paired with a unique ID.
Programming the Z-2400-A2 Series.
uP Configure Software.
The 'uP Configure' software is free to download from Intech's website:
www.intech.co.nz/downloads
uP Configure (version 1.2.8.0 or later) offers a smart, no-fuss setup experience for your Z-2400-A2 wireless nodes.
It allows you to:
Set up the analogue input types of the Z-2400-A2I (Default input is 4~20mA).
Configure the digital inputs and outputs between Z-2400-A2I and Z-2400-A2O nodes.
Set unique ZigBee Mesh ID networks to pair your Z-2400-A2 devices. (The Input and Output nodes are
supplied paired to each other with a unique Mesh ID, however the Z-2400-A2R Repeater will always need to be
paired to the unique Mesh ID.)
Configure the RF output to comply with the wireless standards of your region.
If you are programming the Z-2400-A2I for a MicroScan installation, then you must use 'XU Setup' software, refer to the
'Z-2400-A2I Installation Guide'.
Installing uP Configure.
Note: You must install uP Configure before connecting a Z-2400-A2 wireless node to your computer. If you have
already connected the wireless node using the XU-USB key, please disconnect it before continuing.
1.
Download the latest version of uP Configure from
For ease of access, we recommend saving the install file on your desktop. If you cannot locate the install file,
check whether your browser has saved it in your Downloads folder.
2.
Extract the install file from the zip folder. Right-click on the zip folder and choose 'Extract All', (or extract the file
using another extraction utility of your choice).
3.
Double-click on the extracted 'uPConfigure.msi' install file. This will launch the uP Configure installer.
Depending on your security settings, a 'Security Warning' dialogue may appear. If you see the security message,
click 'Run'. A Windows User Account Control window may also appear. Click 'Yes' to continue.
Note:
uP Configure requires Microsoft .NET 2.0 to
be installed first. If .NET 2.0 is not already installed,
a prompt will advise this so you can install online.
4.
Follow the on screen instructions to complete the installation of uP Configure.
ON indicates power supplied connected.
Flashes to indicate ZigBee® communications active.
See previous table.
www.intech.co.nz/downloads
Note:
An Administrator account or password will be
required for installation. Contact your IT support for
this if needed.
7
Advertisement
Table of Contents
