Table of Contents
Advertisement
Z-2400-A2R
Description.
The Z-2400-A2 series of units support the communication of analogue and
digital signals via a wireless link. The series consists of three separate
wireless nodes for: Input, Output and Repeating, and does not require a
computer to monitor the wireless network. Built on the ZigBee® protocol,
this allows for multiple Z-2400-A2 wireless links to operate side by side at
the same time.
The Output node is the base and acts as the master for the entire link.
The Input node acts as a wireless remote station and seeks for the Output
Base to transmit the input signals to. The Repeater node is the bridge
between the Input and Output wireless nodes, and is only used when the
distance between them is too large to communicate directly.
Ordering Information.
Z-2400-A2R
Repeater node for Wireless Extension.
Z-2400-A2IO
One Wireless Output node and One Input node paired & supplied as a Kit:
Z-2400-A2O
Z-2400-A2I
Note: The Z-2400-A2 Series require the XU-USB Programming Key for Software Configuration:
XU-USB (Rev 1):
THE Z-2400-A2 NODES ARE TO BE INSTALLED AND SERVICED BY SERVICE PERSONNEL ONLY.
NO OPERATOR / USER SERVICEABLE PARTS.
Output Base Wireless node. 2x 4~20mA Outputs, 4x Digital I/O.
Input Remote Wireless node. 2x Isolated Universal Inputs, 4x Digital I/O.
USB Programming Key for programming Z-2400-A2 Series using
uP Configure Programming software.
(Same Key as used for programming XU Series transmitters,
2400-A16, Z-2400-Sleeper, IN-uP4 and uP4-Din.)
CAUTION
Risk of electric shock.
Dangerous and lethal voltages may be present on the terminal of the
device. Please take appropriate precautions to ensure safety.
CAUTION
Risk of Danger.
For your safety, please read completely the instructions prior to installation and operation of the
Z-2400-A2 Wireless Series. In particular, consult this manual in all cases where hazard symbols
are marked on your Z-2400-A2I, Z-2400-A2O and Z-2400-A2R nodes, in order to understand and
avoid potential hazards. The safety of any system incorporating these units is the responsibility of
the assembler of the system.
CAUTION
Observe minimum safe distance.
Intech Instruments Z-2400-A2 nodes comply with CFR47, Section 1.1307(b)(1). For your safety,
please observe a minimum safe distance of 200mm.
3
Wireless Node For
Repeating Z-2400 Signals.
FCC ID
2ACTT-1409
Advertisement
Table of Contents
