Table Of Contents - Intech Z-2400-A2R Installation Manual

Z-2400-A2R Wireless Repeater Installation Guide Index.
Description.
Ordering Information.
Z-2400-A2R Specifications.
Physical Layout Z-2400-A2 Series.
Front Panel Connections and LEDs.
Z-2400-A2R Power Supply Connection.
Diagnostic LEDs.
RF Signal Quality LED Indication.
Output, Input and Repeater Node Network Status LED Definitions.
Power and ZigBee Network LED Indication.
ZigBee Mesh ID.
Programming the Z-2400-A2 Series.
uP Configure Software.
Installing uP Configure.
Z-2400-A2 USB Connection.
Using the uP Configure Software - version 1.2.8.0 or later.
Configuring the Z-2400-A2R.
Troubleshooting.
Considerations & Limitations for Z-2400 Network Systems.
Antenna Options for Z-2400 Wireless Series.
®
ZigBee is a registered trademark of the ZigBee Alliance, Inc.
Product Liability. This information describes our products. It does not constitute guaranteed properties and is not intended to affirm the suitability of a
product for a particular application. Due to ongoing research and development, designs, specifications, and documentation are subject to change
without notification. Regrettably, omissions and exceptions cannot be completely ruled out. No liability will be accepted for errors, omissions or
amendments to this specification. Technical data are always specified by their average values and are based on Standard Calibration Units at 25°C,
unless otherwise specified. Each product is subject to the 'Conditions of Sale'.
Warning: These products are not designed for use in, and should not be used for patient connected applications. In any critical installation
an independent fail-safe back-up system must always be implemented.
2
Page 3
Page 3
Page 4
Page 5
Page 5
Page 5
Page 6
Page 6
Page 6
Page 7
Page 7
Page 7
Page 7
Page 7
Page 8
Page 8
Page 9
Page 10
Page 10
Page 10