Z-2400-A2 Usb Connection; Using The Up Configure Software - Version 1.2.8.0 Or Later - Intech Z-2400-A2R Installation Manual

Z-2400-A2 USB Connection.

To connect a Z-2400-A2 node to your PC requires the XU-USB Programming Key.
(Same Key as used for programming XU Series transmitters, 2400-A16, Z-2400-Sleeper, IN-uP4 and uP4-Din.)
BEFORE YOU CONNECT:
 Ensure that you have a XU-USB Programming Key and a low voltage power supply (9~36Vdc).
 Install the uP Configure software before connecting the XU-USB to your computer (see page 8). uP Configure may
not be able to detect your Z-2400-A2 node if it was already connected to your computer at the time of installation.
Connecting up:
 Connect the XU-USB key to your computer's USB port and the other end of the cable to the programming port on the
Z-2400-A2 front panel (see page 5), ensuring that the cable between the XU-USB programming key and the
Z-2400-A2 node are firmly 'pushed in'. Failure to do so could cause damage to your computer.
 Connect your Z-2400-A2 node to a low voltage power supply (9~36Vdc, Wiring diagram on page 5).
 Confirm the node is working by checking the 'PWR' LED is lit.

Using the uP Configure Software - version 1.2.8.0 or later.

To run uP Configure, double click on the icon on your desktop.
With your Z-2400-A2R connected to your computer via the XU-USB programming key, Click on the Connect button.
The next screen that comes up is the 'Overview' of the Z-2400-A2 node connected.
Z-2400-A2
9~36Vdc
Power Supply
uP Configure Home Screen
CAUTION - Risk of damage.
Ensure that all connections between the Z-2400-A2
node and the XU-USB Key are securely pushed in.
Attempting to connect when cables are not firmly
pushed in may result in connection faults, and
could also cause damage to the unit or your PC.
8